If the same sound card will be used with both radios, select Source = Right 31. Set PTT & FSK to the port used for Router's Radio 2 FSK port. Select the sound card used for Reception and Transmission on Radio Select the TX tab 28. In the Digital Interface, Click Setup Setup MMTTY. Click on Interface MMTTY to activate the MMTTY interface.
Activate the right Entry Window (Radio 2) and open the Digital Interface. Click "OK" to save the settings and close the Configurer.Ĩ 22. Set the method to determine the mode to log. Note: See the N1MM Logger Help files for the supported RTTY and PSK modes for your radios. Set the appropriate RTTY and PSK modes for each radio. Select FSK as the MMTTY mode for DI-1 and DI Enter the path to each MMTTY installation. Select the Digital Modes tab in the N1MM Logger Configurer.
N1MM LOGGER DIGITAL CHANGE INSTALL
Install MMTTY in two different directories on your hard disk. This configuration is based on using MMTTY in FSK mode. NOTE: When using a micro2r FSK port for RTTY with MMVARI, the FSK Port setting must be FSK8250.Ħ FSK with MMTTY: N1MM Logger supports the MMTTY Engine, MMVARI and/or an external TNC for RTTY contesting. Please refer to the N1MM Logger Help and documentation for your particular interface when configuring digital mode support. The information below is provided as a matter of convenience. NOTE: Other than setting the correct virtual port for FSK (if used) with MMTTY or MMVARI, the digital configuration is identical to that used with your existing digital interface. Set Recording channels to Two (2) if you have connected both receivers to the Line input of the sound card being used for QSO Recording. NOTE: Selection of the QSO Recording Device will be dependent on your digital connection. Select Microphone as the Message Recording Port. Select the soundcard you are using with micro2r as the Message Recording Device. Select microphone as the Port to Mute 16. Select the soundcard you are using with micro2r as the Output Device. Configure Audio for "1 - Zero or Single Card, One Radio, No Sound Card SO2R" 14. Use the PTT & ACC tab to select whether micro2r is to generate PTT for each radio (Generate PTT Output).ĥ 13. Enabling WinKey will disable LPT CW and PTT.
N1MM LOGGER DIGITAL CHANGE PC
Note: N1MM Logger does not support WinKey and PC Generated CW at the same time. If you prefer to use PC Generated CW on the LPT port check Use LPT for CW and Use LPT for PTT. Use the PTT & ACC tab to select PTT or QSK operation in CW (Use WinKey PTT). Suggestion: If you are using microham CAT/CI-V interfaces, use the FSK ports in those devices instead of FSK in micro2r. Assign ports for FSK and check the PTT box.
Connection data is in the micro2r User Manual.
N1MM LOGGER DIGITAL CHANGE SERIAL
They can be anything from traditional serial ports to microham microkeyer II. You will need a CAT/CI-V interface for each radio. micro2r does not provide transceiver control. The key is consistency - the same port number must be used for a specific function in both Router and the logger. 1 Router setup: micro2r and N1MM Logger Setup Classic SO2R Note: The specific port numbers are not important.
0 kommentar(er)
